al stacker_installed si Trendsetter_400/800_Auto Trendsetter_NEWS The stacker_installed parameter is used to indicate to the firmware that plates are being ejected onto a plate stacker instead of into a plate processor. If this parameter is set to 1, the plate will be ejected off of the table at full speed instead of slowing down to match the processor speed. byte

0

0 to 1

cfg

../nvs/alpos_cal_fed.xmlNVS: alpos fed

../nvs/alpos_cal_seo.xmlNVS: alpos seo

..\..\ShowAllErrors.htmFirmware 0 Error Index

..\..\ShowAllCommands.htmFirmware 0 Command Index

..\..\ShowAllNVS.htmFirmware 0 NVS Index

Updated: Wed Jul 16 19:35:57 2008 PST